Why is the welding effect not up to standard after the ultrasonic welding machine changes the mold?
Publisher: Administrator Date:2023-03-24
Ultrasonic welding machine is a multi-purpose machine. The ultrasonic welding tooling of different products needs to replace the corresponding product mold. Therefore, the next product welding machine not only needs to replace the ultrasonic mold online, but also needs several important steps.
Many inexperienced operators of ultrasonic welding machines change the ultrasonic welding machine to ultrasonic plastic welding mold, which will lead to poor welding effect and unqualified products. Employees are not familiar with the operation, and often cannot find out the problem, They will say, "Obviously, the ultrasonic welding machine is good. Why did something go wrong suddenly? In fact, the welding effect of the ultrasonic welding machine is not good after the replacement of the ultrasonic welding machine mold, which does not meet the standard. Basically, it is not the problem of the ultrasonic welding machine, but it is not caused by the correct debugging after the replacement of the mold.
When this problem occurs, the welding effect shall meet the standards of the following steps:
1: Install the mold and test whether the frequency of the mold is correct.
2: Test whether the die acoustic wave is normal according to the acoustic wave detection.
3: Adjust the level
4: Install the bottom die and correct the specific position of the product.
5: Then weld.
According to the above steps, when the welding is still good, the operation will not occur. How to replace the mold of the ultrasonic welding machine? If there are any problems in the welding in the future, please contact us directly, and we will try our best to solve the problem for you.